Cisco AS5200 - Universal Access Server Quick Start Manual page 13

2
Install the Universal Access Server (continued)
To power
outlet
Connect a Power Cable and
Power on the Universal Access
Server
Step 1
Connect one end of the power cord to the
power connector on the rear panel of the
access server.
Step 2
Connect the other end of the power cord
to the power outlet.
Step 3
Power ON the access server. Messages will
begin to appear on your console screen.
Universal access server
Power
switch
Caution
kIt may take several minutes for
the startup messages to stop. Do not press
any keys until you see the following
message:
Would you like to enter the initial
configuration dialog? [yes]:
While you are waiting for this message to
appear, proceed to Section 3 .
11