Cisco AS5200 - Universal Access Server Quick Start Manual page 6

2
Install the Universal Access Server (continued)
4
Connect the Ethernet Port for
10BaseT Ethernet LAN Access
You can connect the access server to a 10BaseT or
thick Ethernet network. For a thick Ethernet
connection, proceed to the next section, "Connect
the Ethernet Port for Thick Ethernet LAN Access."
You will need an Ethernet transceiver and cable to
connect the access server to a 10BaseT hub.
Note: The cable, transceiver, and hub are not
included.
Ethernet AUI port (DB-15)
Ethernet
transceiver
8
Straight-through
10BaseT cable
Universal access server
10BaseT hub
7
1
Step 1
Step 2
Step 3
Note: The Ethernet ports on the access server and
the hub must have the same baseband.
Connect an Ethernet transceiver to the
port labeled AUI on the rear panel of the
access server.
Connect an Ethernet cable to the Ethernet
transceiver.
Connect the other end of the Ethernet
cable to a 10BaseT hub.