Sfp Gbic Module; Factory Defaults Button - NETGEAR GS724AT - ProSafe Gigabit Smart Switch Hardware Installation Manual

GS700AT Hardware Installation Guide
•

"Factory Defaults Button"

RJ-45 Ports
RJ-45 ports are auto-sensing ports. When inserting a cable into an RJ-45 port, the switch
automatically ascertains the maximum speed (10/100/1000 Mbps) and duplex mode (half-or full-
duplex) of the attached device. All ports support only Unshielded Twisted-Pair (UTP) cable
terminated with an 8-pin RJ-45 plug.
To simplify the procedure for attaching devices, all RJ-45 ports support Auto Uplink. This
technology allows attaching devices to the RJ-45 ports with either straight-through or crossover
cables. When inserting a cable into the switch's RJ-45 port, the switch automatically:
• Senses whether the cable is a straight-through or crossover cable.
• Determines whether the link to the attached device requires a "normal" connection (such as
when connecting the port to a PC) or an "uplink" connection (such as when connecting the
port to a router, switch, or hub).
• Configures the RJ-45 port to enable communications with the attached device, without
requiring user intervention. In this way, the Auto Uplink technology compensates for setting
uplink connections, while eliminating concern about whether to use crossover or straight-
through cables when attaching devices.

SFP GBIC Module

The GBIC module bays accommodate standard SFP GBIC modules, such as the AGM731F,
AGM732F, or AGM733 from NETGEAR, allowing fiber connections on the network. The module
bay is a combo port, sharing a connection with an RJ-45 port. Being a combo port, only one type
of connection can be active at any given time. For example, both copper and fiber port cannot be
used at the same time. If both connectors are plugged in at the same time, the fiber port becomes
active.
The SFP GBIC bay accommodates a standard SFP GBIC module.
Factory Defaults Button
The Smart Switch has a Factory default button to enable clearing the current configuration and
returning the device back to the factory settings. This removes all settings, including the password,
VLAN settings and port configurations.
Physical Description
v1.0, December 2007
3-21