The File Index - Kurzweil K2600 - MUSICIANS GUIDE REV A PART NUMBER 910330 CHAP 13 Manual

Disk Mode
File List Dialog
If you are in a directory that is more than one level down from the root directory, such as
\FX2\GLASS\BREAKING, the display will read:
Dir:..\BREAKING\|Sel:0/54||||Index:||24|
The Ò..\Ó indicator tells you that you are more than one level down from the root directory.

The File Index

On the right side of the top line is the Index Þeld. This tells the position of the highlighted Þle
relative from the beginning of the Þle list. The Þrst entry in a Þle list is index 1.
Dir:\||||||||||||Sel:2/23||||Index:|||3|
|||||||||||||||||AXM||||||.K26*|||122K||
|||||||||||||||||CHIME||||.K26|||||42K||
||||File|to|load:DOORS||||.K26*||3456K||
|||||||||||||||||JUNE27|||||||(dir)|||||
|||||||||||||||||LONGSMPS|||||(dir)|||||
|Total:21034K||||FLUTE||||.K26|||||.5K||
Select||Root||Parent||Open|||OK|||Cancel
Typing a number on the alphanumeric buttonpad will automatically scroll the display to the
corresponding entry in the Þle list. Typing an out-of-range value such as 999 is a quick shortcut
to get to the end of the Þle list.
In addition to remembering the current directory on the most recently used disk, the K2600 also
remembers the index within the Þle list for the current directory. For example, if you were to hit
Cancel on the above page, go to Setup mode to check the current setup, then return to Disk
mode to load a Þle, the Þle index would still show 3 DOORS.K26 after you pressed Load. This
index is remembered until a new disk is selected by changing the value of the Current Disk
parameter on the Disk-mode page.
There are exceptions to this however. For example, when a Þle is written to the disk using the
Save function, the index will subsequently be set to the Þle that was just saved. The index can
also be explicitly set using the List and Find utilities (see Disk Utilities on page 13-60).
If there are no Þles in the current directory, then the index is 0, and no value appears for the File
to load parameter:
Dir:\||||||||||||Sel:0/0|||||Index:|||0|
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||File|to|load:|||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|Total:|0K||||||||||||||||||||||||||||||
Select||Root||Parent||Open|||OK|||Cancel
The maximum number of Þles that can be accessed within a single directory is 360. If you have
more Þles than this amount in a single directory, then you will not be able to view the entries
past index 360.
13-9