Table of Contents
Advertisement
Disk Mode
Macros
The following page is what you will see if macro recording is Off:
Func:MACRO||||||[|Off||]|||||Index:|||0|
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
Select|Modify||Load||Record||On||||Exit|
The top line displays the disk function, the current macro mode, and an index value into the
Macro table.
Func:MACRO||||||[|On|||]|||||Index:|||0||
Macro Modes
The K2600 has three macro modes: Record, Pause, and Off.
Off
Record
Pause
Note that whenever macro mode is Off, there are two soft buttons labeled Record and On.
Pressing On will enable Macro Record mode, and then will return to the Disk-mode page. As an
alternative, pressing Record will also enable Macro Record mode, but the display will remain on
the MACRO page. Once you press Record, the soft buttons and the top line of the display will
change. The display will look like this:
Func:MACRO||||||[Record]|||||Index:|||0|
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
Select|Modify||Load||Pause||||Off||Exit|
The new macro mode is displayed ([Record]), and the soft button that used to say Record now
says Pause. The soft button that used to say On now says Off. Pressing Pause will cause the
macro mode to read [Pause] and the Record soft button will reappear. You can switch between
Record and Pause by pressing this button repeatedly.
13-44
There is no Macro table in the K2600.
A Macro table exists, and the K2600 adds all Þle-loading operations to the Macro
table.
A Macro table exists, but the K2600 does not add Þle-loading operations to it.
Advertisement
Table of Contents
