Kurzweil K2600 - MUSICIANS GUIDE REV A PART NUMBER 910330 CHAP 13 Manual page 58

Disk Mode
Macros
The insert point can be disabled before loading, by pressing Insert again and pressing Cancel
from within the Set Macro Insert Point dialog. The (Macro insert) indicator will disappear.
Similarly, the insert point can be changed before loading by pressing Insert again (the display
will highlight the current insert point,) scrolling to a different insert point, and pressing OK.
Executing the RAM Macro Table
You can load any group of Þles listed in the RAM Macro table. This is done using the Load soft
button on the MACRO page:
Func:MACRO||||[Record]|||||||Index:|||1|
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|1:\STRINGS.K26||||||||||||||||200:F:|||
*1:\PIANO.K26||||||||||||||||||300:F:|||
|1:\DRUMS.K26||||||||||||||||||400:F:|||
*1:\NOISE.AIF||||||||||||||||||500:F:|||
Select|Modify||Load||Pause|||Off|||Exit|
Pressing the Load button gives you the choice of loading either all of the Þles in the Macro table
or loading only the Þles that are selected:
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
Load|selected|items|or|all|items?|||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|||||||||||||||||||||All|Selected|Cancel
If you donÕt have any items explicitly selected (with an asterisk), the message you see when you
press Load is slightly different:
Load|current|item||or|all|items?|||||||
The current item is the Þle that was highlighted on the MACRO page.
The Þles that have been selected for loading will be loaded in their respective order in the Macro
table, using the bank and mode parameters that are speciÞed in the list. In the example diagram
above, if you were to load selected items, Þrst \PIANO.K26 would be loaded into the 300s bank,
and then \NOISE.AIF would be loaded into the 500s bank.
Saving and Loading a Macro Table in a .K26 file
Macro table objects can be explicitly saved or loaded (without being ÒexecutedÓ) using Save
Individual Object and Load Individual Object. If for some reason you wanted to save a Macro
table that youÕve been working on, and then be able to load it again later on to be worked on
some more, you would use this method. The Macro table can be selected for saving and loading
just like any other object. When you load a Macro table using Load Individual Object, it will
overwrite any Macro table already in memory. Once it is loaded, you may have to go to the
13-58