Shortcuts When Saving Objects - Kurzweil K2600 - MUSICIANS GUIDE REV A PART NUMBER 910330 CHAP 13 Manual

Shortcuts when Saving Objects

Select All/Deselect All
Selecting or deselecting all of the objects at once can be done with the following double-presses
(two front-panel buttons simultaneously pressed):
¥ Left/Right cursor double-press: Select All Objects
¥ Up/Down cursor double-press: Clear All Selections
If you want to save most but not all of the items from a Þle (for example, if there are some songs
in RAM that you donÕt want to be saved in the Þle), it may be fastest to Þrst select all objects
using the Left/Right double-press, and then manually deselect any unwanted items.
Viewing Selected Objects
When there are lots of objects selected, but they are scattered in the objects list, it can be helpful
to be able to view a list of only the currently selected objects. Do this by double-pressing the
Chan/Bank buttons.
¥ Double-press of Chan/Bank buttons: View Selected Objects
For example, if there were 10 objects selected, and you pressed both Chan/Bank buttons
simultaneously, the K2600 would show a list similar to this:
View|Selected|Objects||10/134|||||||||||
Program|300|Biggest|Kit||||||||||||7124|
Program|301|Repercussions||||||||||7124|
Song||||300|Drum|Groove|7|||||||||12092|
Song||||301|Drum|Groove|8|||||||||24700|
Song||||421|Nasty|Funk|||||||||||||3122|
Song||||500|Beethoven||||||||||||||1024|
||||||||||||||||||||||||||||||||||||OK||
The top line shows 10 objects selected out of the 134 that are currently in RAM. If the number of
selected objects is larger than the 6 objects that Þt on one page (as in this example), the list can be
scrolled to view all of the information.
Note that this feature is not available in the Load Object dialog.
Disk Mode
Saving Files
13-27