Soft Buttons On The Track Page - Kurzweil K2600 - MUSICIANS GUIDE REV A PART NUMBER 910330 CHAP 12 Getting Started Manual

Song Mode and the Song Editor
Song Editor: The TRACK Page
When Events is Set to Controller
If your song contains any MIDI Controller data, the Ctl parameter is used to select particular
controller data to be edited. Refer to the Control Source list in Chapter 6 of the Reference Guide.
LoVal
You may further specify a particular range of values to edit by setting a high and low value.
LoVal will deÞne the lowest modiÞable value in the selected controllerÕs recorded data. Value
ranges are not deÞnable when Ctl is set to All. Available Values are 0Ð127.
High Value (Hi)
Hi deÞnes the highest modiÞable value in the selected controllerÕs recorded data. Value ranges
are not deÞnable when Ctl is set to All. Available Values are 0Ð127.

Soft Buttons on the TRACK Page

FromTo is a quick way to deÞne the region of time you intend to edit. There are a couple of ways
to use this feature when the sequence is playing back in real time, and both ways will set the
temporal boundaries of the region to a Þner resolution than Bars and Beats.
One way is to Þrst position the cursor over the From parameter in the Region/Criteria box and
then press the Play soft button. During playback, every time you press FromTo, the K2600
updates the value of From to match the current playback location. Position the cursor over the
To parameter to change the value of To in a similar fashion.
If you havenÕt selected either the From or To parameter, pressing FromTo during playback
updates From or ToÑor bothÑdepending on the current playback location (the value of the
Locate parameter) at the time you press FromTo. If you press it while the Locate value is earlier
in the song than the current To value, the K2600 updates the From value. If you press FromTo
again (without stopping playback) while the Locate value is later than the current From value,
the K2600 updates the To value.
Play will start the playback of the song from the Bar and Beat set in the Locate parameter. When
the song is playing, this soft button becomes Pause.
Stop stops the playback of the song and return to the Bar and Beat set as the Locate value.
Go performs any of the Track-based edit functions described above.
Done will return you to the EditSong : COMMON page.
12-50