Glossary Of Terms - Dimension One Spas Dynamic Massage Sequencer Owner's Manual

Glossary of Terms

Term
Bleeder Valve
Circulation
Pump
Dry Firing
Equipment
Access Panel
Filter Cartridge
GFCI-Ground
Fault Circuit
Interrupter
Gravity Drain
Valve
Halogens
ICON Pad
Jets
Light
Load Sharing
Lower Control
System
Ozone
Generator
Flow Switch
Pump
Selector Valve
Serial Number
Slice Valves /
Shutoff Valves
30
2002 Dimension One Spas Export Owner's Manual
Definition
A small valve used to relieve or expel air from the spa's plumbing or pump.
A pump that circulates the water in the spa continuously.
Turning the heater element on when there is no water in the heater.
Provides access to your spa's equipment for a qualified service technician.
Your spa's filters have been designed so that you may repeatedly clean and
maintain the filter element as needed. The element is constructed of woven
polyester rather than paper to ensure long life and proper filtration.
A type of Circuit Breaker that automatically disconnects power to the spa when
there is an electrical power leakage to ground.
Used to drain your spa
Free chlorine, bromine or iodine ions that are very strong oxidizers used to
sanitize water.
This is a pad accessed by pressing the Dimension One Spas Logo on the far right
of the Top Side Control Panel.
Return the water into the spa from the equipment. The jets produce a turbulent
flow of water mixed with air to provide a concentrated body massage
Illuminates the spa
When the circuit breaker size is smaller than the total power needed to operate
both the heater and the jet pump at the same time, load sharing automatically
turns off the heater when a jet pump is turned onto high speed.
The electronic control system that governs all of the electrically operated
components of your spa utilizes an advanced microprocessor and solid-state
electronic devices to activate all user and maintenance options. A backlit, highly
reliable liquid crystal display gives you a complete update of the spa status at any
time of the day or night. Temperature setting, as well as control of the light, jets,
filtration, and time of day display, are all instantly available from, and controllable
at, the topside control panel.
A specialized ultraviolet light that changes oxygen into ozone for use in the water
sanitation process.
Safety device(s) that sends a signal to the electronic control system that there is
adequate water flow to turn the heater on.
Produces water flow through the heater, filter, sanitation system and the main
jets in the spa. The pump will operate automatically during filtration and heat
cycles. This pump can also be operated manually by depressing the "jets" pad on
the topside control panel which will allow you to choose between two speeds
•
Low speed for efficient water circulation during heating and filtration
modes, and for gentle jet resistance or massage action.
•
High speed for maximum jet action.
Located on the top edge of the spa, it diverts jet power from one area of the spa
to another.
Please use the serial number (located on the left corner pedestal) in
communication with your dealer.
Valves located within the spa's internal plumbing, which are used by service
personnel to shut off water flow to the heater and pumps. All valves must be