Dimension One Spas Dynamic Massage Sequencer Owner's Manual page 12

Control
3
4
5
6
7
8
2002 Dimension One Spas Export Owner's Manual
3.
LIGHT Pad and Status Light Push the LIGHT pad once to activate the
brightest setting (Status Light will illuminate, 1). A second push will activate the
medium setting and a third push will activate the dimmest setting. Push the
LIGHT pad a fourth time to turn off the light. The light will automatically turn
off after one hour.
NOTE: If the Dynamic L.E.D. Light is installed, the low, medium, and high
settings are disabled. The Light pad turns the Dynamic L.E.D. Light on and off.
4.TEMPERATURE Pads
Pushing the UP (+) pad increases the temperature and pushing the DOWN (-)
pad decreases the temperature. Push the respective pad one time for each
degree of temperature change, or push and hold the pad for rapid adjustment.
The actual hot tub water temperature will remain in the Digital Display
window until a temperature pad is pushed. When the UP or DOWN pad is
pushed the Digital Display will indicate the new temperature setting, with the
SET POINT Icon on the right side of the Digital Display. Once the new
temperature is set, the actual hot tub water temperature will again be
indicated. The hot tub will heat to the pre-set temperature automatically.
5.
PROGRAM Pad
The PROGRAM pad is used for several different functions including: Clock Set,
Filter Cycle Start Time, Filter Cycle Duration, Number of Filter Cycles, and
Temperature Unit Selection. The paragraphs following this table will explain
how these features are set.
To initiate the programming sequence at any time, push and hold the
PROGRAM pad for 3 seconds. If, within 60 seconds, you do not proceed with
the hot tub programming, the hot tub will automatically exit the programming
sequence and revert to the previous settings. To exit the programming
sequence at any time, do not press any pad for 10 seconds. Any programming
changes made up to that point will be saved.
6.
Dimension One Spas ICON (Logo)
The time of day can be viewed by pushing the Dimension One Spas ICON logo
on the far right of the control. If no other pad is pushed within 5 seconds, the
display will revert to the hot tub water temperature reading. The pre-set
factory default is Fahrenheit.
Pressing the logo for 5 seconds will place the spa in the "Standby" mode and
allow the spa to be cleaned without turning off the power.
7.
Heat Status Light
This Light is illuminated whenever the heater is on.
Function