Selecting An Equaliser Mode From Memory; Measuring/Display Frequency Characteristic - Eclipse CD8445E Owner's Manual

Various Settings
Selecting an equaliser mode from
memory
ATTENTION
For details on the operation, please
contact your dealer.
Press a preset button to select the equaliser
mode set in memory for the button. The buttons
that set equaliser modes in memory are called
preset buttons.
Turn the [SEL] button to select
1
PEQ.
2
Press the [SEL] button.
Select any button, from [1] to [5],
3
and press it for less than two
seconds.
The preset pattern stored in memory
will be retrieved.
4
Press the [RTN] button.
At this time, other adjustments can
also be made in normal mode.
Press the [SOUND] or [RTN]
5
button to exit sound adjustment
mode.
ATTENTION
When the preset value is changed, the
display shows as follows:
1-5 Preset ch No.
Measuring/display frequency
characteristic
Frequency characteristics inside the vehicle
can be measured and displayed on the display.
The measurement result can be referred to
when adjusting parametric equaliser. This
result is also necessary to automatically correct
parametric equaliser setting using Sound effect
customisations.
ATTENTION
• Adjust time alignment (see page
174) and crossover (see page
184) before measuring frequency
characteristics.
• When
characteristics,
Loudness
automatically cancelled.
Connect the optional microphone
1
with a RCA connector to the L-CH
of the AUX jack of the deck.
Turn the [SEL] button to select
2
the PEQ.
Align the microphone with the actual
ear position and attach it to the
headrest or other appropriate fixture.
(Attach the microphone using tape or
string.)
3
Press the [SEL] button.
The mode
parametric
mode.
Press the [AUDIO CONTROL]
4
button for less than two seconds.
After pushing the button, a 10-
second countdown begins. Leave the
vehicle during that time.
Pink noise will be output from the
speakers and measurement of the
frequency characteristics will start.
[Measuring] will appear on the
display while measurement is in
progress. When measurement is
complete, the measurement results
180
measuring frequency
CSII
settings
will be change
equaliser adjustment
and
are
to