Manually Setting Stations Into Memory; Preset Station Scan; Changing The Reception Sensitivity For Automatic Scanning - Eclipse CD8445E Owner's Manual

• If there are
receivable stations, the stations
set in the remaining buttons will be
retained.
CAUTION
If the vehicle's battery is disconnected (for
repairs to the vehicle or for removing the
receiver), all stations in memory will be lost.
In such a case, set stations in the memory
again.
Manually setting stations
into memory
This section covers the setting of stations in
memory under the numbered buttons.
Press the [FM AM] button for less
1
than one second.
You can switch the mode to desired
one.
Turn the [SEL] button to the right
2
or left to tune to the station to be
entered in memory.
Select any button, from [1] to [6],
3
and press it for more than two
seconds.
The tuned
memorized and set in the button
selected. Repeat the procedure to
set additional
stations in memory, in turn, for
buttons [1] to [6]. These buttons
are called the preset buttons.
CAUTION
If the vehicle's battery is disconnected (for
repairs to the vehicle or for removing the
receiver), all stations in memory will be lost.
In such a case, set stations in memory
again.
fewer than six
station is now
manually tuned

Preset station scan

This function enables reception of all the
stations in the preset buttons for five seconds
each.
Press the [SEL] button for less
1
than two seconds.
[P SCAN] will appear on the
display, and stations stored under
preset buttons [1] through [6] will
be played for five seconds each.
To stop the preset scan mode at a
2
desired station, press the [SEL]
button again.
The receiver will stay tuned to the
desired station.
Changing the reception
sensitivity for automatic
scanning
The deck lets you select the reception
sensitivity to be used for automatic scanning of
stations. The two sensitivity modes available
for this deck are AUTO mode and DX mode.
During automatic scanning, the
reception sensitivity switches
automatically to one of two levels.
Initially the reception sensitivity is
set to the low level so that only
AUTO
stations with strong signals are
Mode
received. If no stations could be
received, the reception sensitivity is
increased so that stations with
weaker signals can also be
received.
Because the reception sensitivity for
automatic scanning is set to the high
level from the start, even stations
DX Mode
with weaker signals can be received.
(Signal crossover may result in
some stations being hard to hear.)
151
How to operate the tuner
VII