How To Operate The Esn (Memory Stick) Security; How To Record A Security Code; How To Cancel The Memory Stick Security - Eclipse CD8445E Owner's Manual

Various Settings
How to operate the ESN
(Memory Stick) security

How to record a security code

Check that the unit is in
1
standby.
Press and hold button [1], then
2
the [FUNC] button, and hold both
for more than one second.
A [SEC] message appears, in two
seconds it will change to [MS].
ATTENTION
• If a Memory Stick has already
been inserted, a [MS EJECT]
message appears. In this case,
eject the Memory Stick and insert
again. (Refer to "Ejecting the
Memory Stick" on page 147 for
details on ejection of the Memory
Stick.)
• If the security is already activated,
recording the
function is not available.
Insert the Memory Stick into the
3
slot and close the front panel.
A [- - - -] (security code input display)
appears.
(Refer to "Listening to MG Memory
Stick" on page 43 for details on
insertion of the Memory Stick.)
Input a security code by pressing
4
buttons [1] to [4].
Enter a four-digit security code using
digits 0 to 9, A to F. The number
(shown on the display) changes in
ascending order between 0 and 9, A
and F each time the button is
pressed. Each button number (1 to 4)
security code
164
corresponds to each digit (first to
fourth) of the security code.
Press the [FUNC] button for
5
more than one second.
The security code is registered in the
deck and security is set.
The registered security code is
encrypted and
Memory Stick.
ATTENTION
When the security code is registered
using a Memory Stick that contains
several kinds of data, such as music, etc.,
be careful not to clear the recorded data
by formatting the Memory Stick.
6
Eject the Memory Stick.
Refer to "Ejecting the Memory Stick"
on page 94.
How to cancel the Memory Stick
security
The security function can be cancelled when
the security code that has been recorded with
the deck is entered and verified.
Cancelling the security function can be done by
entering the security code into the deck, or by
using the Memory Stick.
Cancelling the security function by
entering the security code
1
Check that the unit is in standby.
Press and hold button [1], then
2
the [FUNC] button, and hold both
for more than one second.
A [SEC] message appears, then in
two seconds it will change to [- - - -]
(Security code input display).
then written to