Troubleshooting - Bissell PROLITE MULTI CYCLONIC User Manual

T
roubleshooting
Vacuum cleaner won't turn on
Possible causes
1. Power cord not firmly plugged in
2. Electronic protector activated
3. Hose handle not full attached
Brush not rotating fully
Possible causes
1. Brush control button turned "OFF"
2. Vacuum is in upright position
3. Brush is jammed
4. Brush needs to be reset
5. Handle not fully attached
Vacuum cleaner won't pick up or low suction
Possible causes
1. Hose not properly attached
2. Dirt container not installed properly
3. Dirt container full
4. Clog in cleaner
5. Filters are dirty
Visible dirt escaping from cleaner
Possible causes
1. Dirt container full
2. Filters or inner cyclone missing or installed incorrectly
3. Dirt container not installed properly
4. Hose not properly attached
5. Hole or crack in hose
Other maintenance or service not included in the manual should be performed by an
Thank you for selecting a BISSELL product.
Please do not return this product to the store.
w w w . b i s s e l l . c o m
WARnInG:
To reduce the risk of electric shock, turn
power Off and disconnect plug from
electrical outlet before performing
maintenance or troubleshooting.
Remedies
1. Check electrical plug
2. Turn vacuum off and unplug, see page 12
3. Remove handle and reinstall
Remedies
1 Make sure brush control button is pushed "ON"
2. Recline vacuum to operate brush
3. Unplug vacuum, remove obstruction or debris
4. Unplug vacuum to reset brush (page 11)
5. Remove handle and reinstall
Remedies
1. Check Twist-n-Snap hose connection and make
2. Correctly position and snap into place
3. Empty dirt container
4. Follow instructions on page 11
5. Check and clean pre-motor filter, check and
Remedies
1. Empty dirt container
2. Check inner cyclone, pre-motor and
3. Make sure dirt container is correctly
4. Check Twist-n-Snap hose connection and make
5. Check hose for holes or cracks and
authorized service representative.
and reset brush (pages 11 & 12)
sure hose is securely seated in hose base
replace HEPA media post-motor
filter if needed
HEPA media post-motor filters for correct
installation
postioned and snapped into place
sure hose is securely seated in hose base
replace as needed
13