Operation; Handle Position; Automatic Height Adjustment - Bissell PROLITE MULTI CYCLONIC User Manual

O
peration
Power and brush on/off control button
The power control button is located on the
handle just above the bendable wand attachment
on the front of the vacuum. Push the power
control button once to turn the vacuum on for
cleaning, and push again to turn the vacuum off
when cleaning is complete.
The brush control button is located just below
the power control button on the handle and
above the bendable wand attachment on the
front of the vacuum. This control button turns
the rotating brush on and off. The brush control
button will turn on automatically when the power
control button is turned on and should be used
for normal carpet cleaning. you may want to turn
the brush control button off by pushing the brush
control button once for bare floor cleaning or
other delicate surfaces, or when using the hose.
note: your BISSELL PROlite Multi Cyclonic
vacuum is equipped with a special internal
switch that turns the rotating brush off whenever
the unit is in the upright position.

Handle position

1. Upright- For storage and above floor
cleaning with special tools.
2. normal Cleaning- Press handle release
pedal once. Use for most household floor
cleaning tasks.

Automatic height adjustment

The powerfoot on your vacuum has an
automatic height adjustment and does not
need to be manually adjusted when cleaning
various floor surfaces. The foot design enables
the vacuum to move directly from bare floors,
to low pile and high pile carpets automatically.
6 6
w w w . b i s s e l l . c o m
CAUTIOn:
Before using your vacuum, make
sure that both filters (Pre-Motor
and HEPA media Post-Motor)
are in place. Do not operate your
vacuum without these filters.
Tip:
Your vacuum features a Quick-Release
cord wrap. To remove the power cord
quickly and easily, rotate the upper cord
wrap towards floor, and slip power cord
from upper and lower cord wraps..
Power Control
Button
1.
2.
Tip:
Before cleaning under
low furniture, check
area first for objects
that might harm the
unit or block the
vacuum hose.
Brush Control
Button
2.