Yamaha Clavinova CLP-430 Owner's Manual page 71

Owners manual
Hide thumbs Also See for Clavinova CLP-430:
Table of Contents

Advertisement

1.
Attach C to D and E.
1-1
Untie and straighten out the bundled pedal
cord.
Do not discard the vinyl tie. You will need it
later in step 5.
1-2
Attach D and E to C by tightening four long
screws (6 x 20 mm).
D
C
1-1
2.
Attach B.
Depending on the model of instrument you
purchased, the surface color of one side of B
may be different from the other side. In this
case, position B so that the side of the surface
color most similar to D and E faces the player.
2-1
Align the screw holes on the upper side of B
with the bracket holes on D and E, then attach
the upper corners of B to D and E by finger-
tightening two thin screws (4 x 12 mm).
2-2
Secure the bottom end of B using four tapping
screws (4 x 20 mm).
2-3
Securely tighten the screws on the top of B that
were attached in Step 2-1.
E
B
2-2
1-2
E
2-1
2-3
D
3.
Mount A.
Make sure that you mount the main unit by
holding the front bottom in areas that are at
least 15 cm towards the center from either end
and by the handles on the rear panel.
Align the
screw holes
CAUTION
Be extra careful not to drop or let your fingers be pinched by the
main unit.
CAUTION
Do not hold the main unit in any position other than the position
specified above.
4.
Secure A.
4-1
Adjust the position of A so that the left and
right ends of A will project beyond D and E
equally (as seen from the front).
4-2
Secure A by tightening six short screws
(6 x 16mm) from the front.
4-1
Projection of A
A
15 cm or further in
A
A
4-2
Appendix
Assembling the Clavinova
71

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents