Stby/Active Button - Linksys SFE2000P - Managed Ethernet Switch Installation And Administration Manual

LED Off
The
FAN
RPS1000 is
not powered
up.

STBY/ACTIVE Button

Color DC Output Status
Off No device is connected to the output connector.
A device is connected to the output connector.
Green
The RPS1000 is unavailable to the connected device. The
Blinking
green RPS1000 is providing power to another connected device.
The RPS1000 is providing power to the connected device; the
Blinking
amber output is active.
Amber The RPS1000 is in standby mode or in a fault condition.
The RPS1000 has a front panel STBY/ACTIVE button.
NOTE: The RPS1000 is in active mode (STBY/ACTIVE
LED green) when it powers up. It must be in standby
mode every time you connect devices to it.
If you connect a device to the RPS1000 when it is in active mode (STBY/ACTIVE LED green), the
RPS1000 might unnecessarily begin supplying backup power to the device. This situation might
occur if you connect the device before it is powered up, or if the RPS1000 does not immediately
sense that the device power supply was supplying power. In this case, the RPS1000 would not be
available as a backup power source for other connected devices.
Press the STBY/ACTIVE button to change the RPS1000 from active mode to standby mode when you
connect devices. When you change the mode to active, the STBY/ACTIVE LED turns green.
Chapter 2: Product Overview
Front-Panel Description
RPS1000—Business Series 380W RPS Unit Installation & Administration
Green Amber
The fan is The fan is not operating
running. properly.
Chapter
2
6