Mounting The Rps1000 In A Rack; Connecting The Rps1000 - Linksys SFE2000P - Managed Ethernet Switch Installation And Administration Manual

Mounting the RPS1000 in a Rack

After the brackets are attached to the RPS1000, use the four supplied number-12 Phillips machine
screws to securely attach the brackets to the rack, as shown below.

Connecting the RPS1000

CAUTION: Make sure that the RPS1000 is either in
standby mode or that the RPS1000 AC power is
disconnected before you connect the RPS1000 to a
switch. This precaution is necessary because when you
connect the RPS1000 to the AC power, the RPS1000
automatically becomes active.
NOTE: Do not use different power sources to power up
the RPS1000 and the connected device. If you connect to
separate AC power sources, reset conditions might occur.
Chapter 3: Installation
Connecting the RPS1000
RPS1000—Business Series 380W RPS Unit Installation & Administration
Chapter
3
17