Site Requirements; Verifying The Package Contents - Linksys SFE2000P - Managed Ethernet Switch Installation And Administration Manual

Site Requirements

Be sure to observe these requirements as you determine where to place the RPS1000:
WARNING: This unit is intended for installation in
restricted access areas. A restricted access area can be
accessed only through the use of a special tool, lock and
key, or other means of security.
For proper operation, where you locate the RPS1000 is extremely important. If the equipment is
placed too close together, the ventilation is inadequate, and panels are inaccessible, malfunctions
and shutdowns might result, and maintenance will be difficult.
Consider this information when you plan the location of the chassis:
• Provide for access to both the front and rear panels of the RPS1000.
• Make sure that the room where the RPS1000 operates has adequate ventilation. Ambient
air temperature might not cool equipment to acceptable operating temperatures without
adequate ventilation. See the RPS1000—Business Series 380W RPS Quick Installation
Guide for temperature requirements.

Verifying the Package Contents

NOTE: Carefully remove the contents from the shipping
container and check each item for damage. If any item is
missing or damaged, contact your Cisco representative
or reseller for support. Replace all packing material into
the shipping container and save it.
These items are shipped:
• The RPS1000
• This Linksys Business Series RPS1000 Redundant Power System Hardware Installation Guide
• Product Registration Card
• AC power cord
• One 16-pin-to-14-pin DC connector cable
• Mounting kit that contains:
– Four rubber feet for mounting the switch on a table
– Two mounting brackets
– Four Phillips flat-head screws for attaching the brackets to the switch
– Four Phillips truss-head screws for attaching the brackets to the switch
Chapter 3: Installation
Preparing for Installation
RPS1000—Business Series 380W RPS Unit Installation & Administration
Chapter
3
13