Appendix D: Connector And Cable Specifications - Linksys SFE2000P - Managed Ethernet Switch Installation And Administration Manual

Connector and Cable
Specifications
This appendix describes the cable connector that is used to connect the RPS1000 to a supported
device. The cable (CAB-RPS-1614=) is a 48-inch (1.2-meter) cable with a 16-pin connector on one
end and a 14-pin connector on the other end. The following figures show the pinout information.
TIP: The connector is keyed to insert into the receptacle
only in its correct orientation.
14-Pin Connector Pinouts
Top of Connector (Logo Side)
8
1
16-Pin Connector Pinouts
Top of Connector (Logo Side)
9
1
Pin Number 14-Pin Designation
1 GND
2 –48 V
3 12 V
Appendix D:
RPS1000—Business Series 380W RPS Unit Installation & Administration
9 10 11 12 13 14
2 3 4 5 6 7
10 11 12 13 14 15 16
2 3 4 5 6 7 8
16-Pin Designation
GND–48 V
–48 V
12 V
Appendix
D
25