Installing The Switch; Table Or Shelf-Mounting; Rack-Mounting - Linksys SFE2000P - Managed Ethernet Switch Installation And Administration Manual

Cisco rps1000 380w redundant power supply administration guide

Hide thumbs Also See for SFE2000P - Managed Ethernet Switch:

Table of Contents

–

Four Phillips machine screws for attaching the brackets to a rack

Installing the Switch

This section describes these installation procedures:

•

Table or Shelf-Mounting, page 14

•

Rack-Mounting, page 14

WARNING: Do not stack the chassis on any other

equipment. If the chassis falls, it can cause severe bodily

injury and equipment damage.

Follow these steps to install your chassis on a table or shelf:

1. Unpack the RPS1000.

2. Attach the rubber feet from the accessory kit into the round recesses that are located on the

bottom of the chassis.

3. Place the RPS1000 chassis on an appropriate table, shelf, or desktop.

NOTE: If you have questions or need assistance, see the

Appendix C, "Linksys Contact Information," section.

To install the chassis in a 19-inch or 24-inch rack, follow the instructions described in these

procedures.

NOTE: A 24-inch rack requires optional mounting

hardware.

Chapter 3: Installation

Installing the Switch

RPS1000—Business Series 380W RPS Unit Installation & Administration

Chapter

Table of Contents

Sge2000 - cisco - gigabit switch Rps1000