Kyocera KM-1510 Instruction Handbook Manual page 10

1 DF (Document Feeder)
(Open/close to set the original on the platen.)
2 Original table
(Place the originals here.)
3 Original insertion guides
(Adjust the guides to the width of the originals.)
4 DF open/close handle
(Hold this handle when opening and closing the DF.)
5 Original eject cover
(Copied originals are stored here.)
6 DF original switchback cover
(Open this cover to remove a misfed original from the DF.)
7 Operation panel
(Contains the keys and indicators for operating the copier.)
8 Left cover handle
(Hold to open the left cover.)
9 Left cover
(Open when a paper misfeed occurs.)
0 Multi-Bypass
(Load paper here when copying onto small-size or special paper.)
! Insert guides
(Align the guides with the paper width when loading paper on the
multi-bypass.)
@ Support guide
(Pull out when loading paper into the multi-bypass.)
# Toner container
$ Waste toner tank
% Cleaning shaft
(Pull out and push back in several times after toner container
replacement or when copy images are soiled with toner.)
^ Front cover
(Open to replace the toner container and waste toner tank.)
& Main switch
(Turn ON (|) before starting to make copies.)
* Copy storage section
(Copied paper is stored here.)
( Drawer
(Holds up to 250 sheets of standard paper [standard paper as
specified by our company].)
) Platen
(Set originals here for copying. Place originals face-down with the
edges aligned with the size scales on the left and rear sides of the
platen.)
⁄ Original size scales
(Be sure to align the original with these when setting the original
on the platen.)
¤ Length guide
(Adjust to the length of the paper to be set in the drawer.)
‹ Width guide
(Adjust to the width of the paper to be set in the drawer.)
› Width adjustment lever
(Hold the lever and adjust the width guide to the width of the paper
to be set in the drawer.)
fi Length guide storage section
(Store the length guide here when it is not used.)
fl Drawer bottom plate
(Push down when loading paper.)
‡ Handles for transport
(The handles are located on the right and left sides of the copier.
Hold these two handles when moving the copier.)
— Original holder (15 ppm copier)
(Copied originals are ejected onto this holder.)
CHAPTER 2 NAMES OF PARTS
2-2