Safety Of Laser Beam; Optical Unit; Safety Switch - Kyocera KM-1510 Instruction Handbook Manual

SAFETY OF LASER BEAM

1. Safety of laser beam
This copier has been certified by the manufacturer to Class 1 level under the radiation performance standards established by the U.S.
DHHS (Department of Health and Human Services) in 1968. This indicates that the product is safe to use during normal operation and
maintenance. The laser optical system, enclosed in a protective housing and sealed within the external covers, never permits the laser
beam to escape.
2. The CDRH Act
A laser-product-related act was implemented on Aug. 2, 1976, by the Center for Devices and Radiological Health (CDRH) of the U.S.
Food and Drug Administration (FDA). This act prohibits the sale of laser products in the U.S. without certification, and applies to laser
products manufactured after Aug. 1, 1976.
The label shown below indicates compliance with the CDRH regulations and must be attached to laser products marketed in the
United States.
On this copier, the label is on the rear.

3. Optical unit

4. Maintenance
For safety of the service personnel, follow the maintenance instructions in the other section of this manual.

5. Safety switch

The power to the laser unit is cut off when the front cover is opened.
8-3
When checking the optical unit, avoid direct exposure to the
laser beam, which is invisible.
Shown at left is the label located on the cover of the optical
unit.