Dell PowerConnect 3248 Manual page 36

36 Addendum to the 32 48 and 5 224 User 's Guides
NOTICE: The default setting is null, which allows all IP groups SNMP access
to the switch. If one IP address is configured, the IP filtering is enabled and
only addresses in the IP group will have SNMP access.
To add an IP address, type the new IP address in the IP Address box, type
the appropriate subnet mask in the Subnet Mask box, and click Add IP
Filtering Entry. To delete an IP address, click the entry in the IP Filter List,
and then click Remove IP Filtering Entry.
The following figure is representative of PowerConnect 3248 and 5224.
CLI Commands
The following table summarizes the equivalent CLI commands for items in
the SNMP/IP Filtering page.
Command
snmp ip filter ip_address
subnet_mask
Usage
Sets IP addresses of clients allowed to
management access to the switch using SNMP .
The no form command removes an IP address.