Stereo Recording And Playback - Memorex MVR-4040A Owner's Manual

STEREO RECORDING AND PLAYBACK

RECORDING STEREO BROADCASTS
The VHS Hi-Fi audio system permits high fidelity recording of MTS STEREO TV broadcasts.
When a MTS STEREO broadcast is received, the STEREO will appear on the screen and the program can be
viewed or recorded in stereo (refer to pages 36 and 37 for recording procedures). The Hi-Fi STEREO recording
procedure is the same as for normal recordings.
NOTE: When using a CATV system, stereo TV programs may be transmitted over a mono cable channel.
In this case the STEREO will not appear and the sound will be in mono.
OUTPUT SELECTION
When viewing an MTS STEREO TV program, or playing a prerecorded VHS Hi-Fi STEREO videotape, press
this button to select that the audio be heard through both speakers. Normally set to the Hi-Fi STEREO position,
this button can be set to the MONO position if the stereo broadcast or videotape audio is of poor quality. The "R"
and "L" positions allow the audio from the Right or Left Hi-Fi channel to be heard over both TV speakers. This
button has no effect when viewing a MONO videotape or TV program. Each time when you press the button,
OUTPUT SELECTION display appears on the screen for several seconds. Refer to the chart below.
SELECT
•
NOTE: When playing back a tape that is not recorded in Hi-Fi stereo mode, the audio will automatically be monaural.
•
When listening to a VHS Hi-Fi video tape or MTS broadcast through the VHF/UHF jack (Audio/Video cord
not connected), the sound will be monaural.
46
4C90301A-E(P44-47)
STEREO
AUDIO
46
OUTPUT SOUND HEARD ON BOTH
SELECTION SPEAKERS
STEREO STEREO
L CH LEFT CHANNEL AUDIO
R CH RIGHT CHANNEL AUDIO
MONO MONO
26'04'1999, 10:47 AM