Novell ZENWORKS 7.2 LINUX MANAGEMENT - SCENARIOS 1 03-30-2007 Manual page 6

3 : U S I N G T H E P U S H N O W O P T I O N T O I N S T A L L A B U N D L E
I M M E D I A T E L Y A F T E R C R E A T I O N
Objective:
Verify that a bundle gets deployed and installed immediately at the completion of the
Create New Bundle Wizard.
Steps:
1. Ensure that you have installed the ZENworks 7.2 Linux Management server
components and the ZENworks Agent. For detailed information, see
Installation in the
2. On the managed device, ensure that the following zmd preferences are set
with the values mentioned:
• bind-ip must be set to either an empty string or to a valid IP address of the
managed device
• remote-enabled must be set to True
For detailed information on how to set the zmd preferences, see the
ZENworks 7.2 Linux Management Administration
3. In the ZENworks Control Center, create a bundle and assign it to a managed
device. On the Bundle Options page, click the Deploy and install immediately
(when this wizard completes) scheduling option. For detailed information, see
Creating RPM Bundles
Administration Guide
Expected Results:
After the completion of the Create New Bundle Wizard, bundles that have been
scheduled to deploy and install immediately at the completion of the wizard are
deployed and installed on the managed device. Verify that by going to the assigned
managed device and executing a rug bl command. This lists the deployed and
installed the bundle.
ZENworks 7.2 Linux Management Installation
in the ZENworks 7.2 Linux Management
Guide.
Guide.
6
p.