Hp-Ux Agent Install - Novell PRIVILEGED USER MANAGER 2.2.1 - GETTING STARTED GUIDE 03-31-2010 Getting Started Manual

3 When installation is complete, check that the service is running by viewing the log file.
The log file is located in
was used. If the agent installed correctly, it should be listening on 0.0.0.0:29120.
4 Use the following command to register the agent with the Framework Manager. This command
must be issued from the machine where the agent is installed.
/opt/novell/npum/sbin/unifi regclnt register
Four items of information are required:
The registration server hostname: The hostname or IP address of the Framework Manager.
The registration server port: Accept the default unless another application is using this port.
After the host is registered, this port cannot be modified.
The name or IP address of this host: The DNS name or IP address by which any other agent
in the Framework can resolve the location of this machine on your network.
The name of this agent: The name of the agent when it was created in the Framework Console
(refer to "Creating a Host Name for Each Agent" on page
NOTE: When the above details have been provided, a valid username and password for the
Framework Manager are required to complete the registration of the agent.
5 Verify that the registration has been successful by viewing the host details on the Framework
Console.

4.4.2 HP-UX Agent Install

The HP-UX installation package is compressed through gzip. In order to install the package, you
must unzip the package through gunzip.
By default, the installation program installs the software into
directory in the required part of the file system and create a symbolic link to
To install the HP-UX agent:
1 Copy the installation package to a temporary location and use the following command to
extract the installation files:
gunzip <filename>
See the "Novell Privileged User Manager Readme" (http://www.novell.com/documentation/
privilegedusermanager22/readme/privilegedusermanager_readme.html)
filename.
2 After the HP-UX installation package is uncompressed, use the following command to install
the agent:
swinstall -s /<directory of .depot file>/<filename>.depot \*
3 After installation is complete, check that the service is running by viewing the log file.
The log file is located in
was used. If the agent installed correctly, it should be listening on 0.0.0.0:29120.
4 Use the following command to register the agent with the Framework Manager. This command
must be issued from the machine where the agent is installed.
/opt/novell/npum/sbin/unifi regclnt register
/opt/novell/npum/logs/unifid.log
/opt/novell/npum/logs/unifid.log
, if the default install location
27).
. To change this, create a
/opt/novell
/opt/novell
for the actual
, if the default install location
.
Installing the Agents 29