Solaris - Novell PRIVILEGED USER MANAGER 2.2.1 - GETTING STARTED GUIDE 03-31-2010 Getting Started Manual
Hide thumbs
Also See for PRIVILEGED USER MANAGER 2.2.1 - GETTING STARTED GUIDE 03-31-2010:
- Administration manual (154 pages)
Table of Contents
Advertisement
To check the status:
/etc/init.d/npum status
®
Alternatively, you can use the following instructions for all distributions except SUSE
.
To stop the Framework process:
service npum stop
To start the Framework process:
service npum start
To check the status:
service npum status
3.5.4 Solaris
The following instructions apply to all supported distributions.
To stop the Framework process:
/etc/init.d/npum stop
To start the Framework process:
/etc/init.d/npum start
To check the status:
/etc/init.d/npum status
Solaris 10 also uses the SMF (Service Management facility). Example commands are:
svcs | grep npum
legacy_run Apr_21 lrc:/etc/rc3_d/S99npum
online Apr_21 svc:/application/security/npum:default
Then, to enable the Framework process:
svcadm enable npum
To disable the Framework process:
svcadm disable npum
To restart the Framework process:
svcadm restart npum
To clear the Framework process:
svcadm clear npum
Please refer to your Solaris documentation for full SMF instructions.
22
Novell Privileged User Manager 2.2.1 Getting Started Guide
Advertisement
Table of Contents
Need help?
Do you have a question about the PRIVILEGED USER MANAGER 2.2.1 - GETTING STARTED GUIDE 03-31-2010 and is the answer not in the manual?
Questions and answers