Tru64 Framework Manager Install; Windows Framework Manager Install - Novell PRIVILEGED USER MANAGER 2.2.1 - GETTING STARTED GUIDE 03-31-2010 Getting Started Manual

4 If you have been supplied with a license, log in to the Framework Console and install the
license.
For information, refer to
then Section 3.3, "Installing a Novell Privileged User Manager License," on page

3.1.5 Tru64 Framework Manager Install

The Tru64 installation package is compressed through gzip. In order to install the package, you must
unzip the package through gunzip.
By default, the installation program installs the software into
create a directory in the required part of the file system and create a symbolic link to
.
npum
To install the Tru64 manager:
1 Copy the installation package to a temporary location and use the following command to
extract the installation files:
gunzip <filename>
tar –xvf <filename>
See the
privilegedusermanager22/readme/privilegedusermanager_readme.html)
filename.
2 After the Tru64 installation package is uncompressed, use the following command to install the
manager:
setld -l NOVELLNPUM/
3 After installation is complete, check that the service is running by viewing the log file. The log
file is located in
used. If the manager installed correctly, services should be listening on 0.0.0.0:29120 and
0.0.0.0:443.
4 If you have been supplied with a license, log in to the Framework Console and install the
license.
For information, refer to
then Section 3.3, "Installing a Novell Privileged User Manager License," on page

3.1.6 Windows Framework Manager Install

1 Run the following install executable to start the installation:
<filename>.exe
See the
privilegedusermanager22/readme/privilegedusermanager_readme.html)
filename.
2 Follow the steps in the install wizard.
The Framework Manager service can be installed on any part of the normal file system. It
defaults to the
18 Novell Privileged User Manager 2.2.1 Getting Started Guide
Section 3.2, "Accessing the Framework Console," on page
"Novell Privileged User Manager Readme" (http://www.novell.com/documentation/
/opt/novell/npum/logs/unifid.log,
Section 3.2, "Accessing the Framework Console," on page
"Novell Privileged User Manager Readme" (http://www.novell.com/documentation/
C:\Program Files\Novell\npum
/opt/novell/npum
for the actual
if the default install location was
for the actual
folder.
19, and
20.
. To change this,
/opt/novell/
19, and
20.