Novell OPEN ENTERPRISE SERVER 2 SP2 - PLANING AND IMPLEMENTATION GUIDE 11-10-2009 Implementation Manual page 255

Services Associated with Scripts
Novell Remote Manager
Novell Storage Services TM
Novell Remote Manager e-mail
notifications
NTP
OpenWBEM CIMOM
Patching
®
Red Carpet
Samba
Samba CIFS support
SLP support
Storage Management Services
Tomcat
Script Name
novell-httpstkd
novell-nss
postfix
ntp
owcimomd
novell-zmd
rcd
nmb
smb
slpd
TM novell-smdrd
novell-tomcat5
Notes
This script runs by default on every OES 2
server and enables access to NRM for
Linux through a browser.
Use this script followed by the status option
to view current status. Or use stop, start, or
restart options to alter the run state of the
NRM daemon as needed.
This script runs by default on every OES 2
server with NSS volumes and enables
access to the NSS runtime environment.
To see if the NSS kernel modules and NSS
admin volume are running, enter
,
novell-nss status /etc/init.d/
, or
novell-nss status
at a command prompt. If they are
status
not running, use the
start
them. You cannot stop NSS.
Novell Remote Manager uses this to send
notifications as configured.
This is the SLES 10 Network Time Protocol
daemon.
This is used to start the OpenWBEM
CIMOM daemon, which is an integral part
of the iManager plug-ins for LUM, Samba,
NSS, SMS, and NCS. iPrint and NRM also
use OpenWBEM.
Novell Remote Manager on OES 2 gets its
server health information from CIMOM.
This is the GUI patch updater daemon.
This is the rug command line daemon.
This is the Samba NetBIOS naming
daemon.
This script runs the Samba daemon.
This lets you start and stop OpenSLP,
which is a key component for eDirectory
and certain other services and clients.
This lets you start and stop the SMDR
daemon precess. It also loads and unloads
the NSS zapi kernel module used by SMS
to back up the NSS volumes.
This script sets up the SLES 10 Tomcat
specifically for OES 2 services, such as the
Welcome pages.
service
rcnovell-nss
option to start
OES 2 Service Scripts 255