New In Oes 2 Sp1; Cross-Protocole File Locking Change; Domain Services For Windows Installation; Performance Increases - Novell OPEN ENTERPRISE SERVER 2 SP2 - PLANING AND IMPLEMENTATION GUIDE 11-10-2009 Implementation Manual

Planning and implementation guide
Table of Contents

Advertisement

1.3.5 Cross-Protocole File Locking Change

Starting with OES 2 SP2, cross-protocol file locking (CPL) is enabled by default as follows:
All new servers with NCP installed have CPL turned on.
If an upgraded server was not configured for CPL priot to the upgrade, CPL will be turned on.
If an upgraded server was configured for CPL priot to the upgrade, the CPL setting
immediately preceding the upgrade is retained.
If a server is only accessed through NCP (AFP and CIFS are not installed), you can achieve an NCP
performance gain of about 10%. However, there is a critical caveat. If you later install AFP or CIFS
and you forget to re-enable CPL, data corruption can occur.
There are also obvious implications for clustering because the CPL settings for clustered nodes must
match. For example, if an unmodified OES 2 SP1 node is clustered with an unmodified OES 2 SP2
node, their CPL settings will conflict and one of the nodes must be modified.
For more information about cross-protocol locking, see
NCP
Server" in the

1.3.6 Domain Services for Windows Installation

The DSfW installation has been rearchitected with a focus on usability and simplicity.

1.3.7 Performance Increases

AFP, NCP, and Samba all have improved performance in OES 2 SP2.

1.3.8 PureFTP

Gateway parity with NetWare.

1.3.9 Upgrading Online

Support for upgrading through the SP Channel is included. For more information, see
Using the Patch Channel

1.4 New in OES 2 SP1

Section 1.4.1, "YaST Install Changes," on page 20
Section 1.4.2, "Novell AFP," on page 21
Section 1.4.3, "Novell CIFS," on page 21
Section 1.4.4, "Novell Domain Services for Windows," on page 22
Section 1.4.5, "Migration Tool," on page 22

1.4.1 YaST Install Changes

The default behavior of the option to use eDirectory
OES 2 SP1.
20
OES 2 SP2: Planning and Implementation Guide
OES 2 SP2: NCP Server for Linux Administration
(Online)" in the
OES 2 SP2: Installation
"Configuring Cross-Protocol File Locks for
Guide.
Guide.
certificates for HTTPS services changed in
TM
"Upgrading

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the OPEN ENTERPRISE SERVER 2 SP2 - PLANING AND IMPLEMENTATION GUIDE 11-10-2009 and is the answer not in the manual?

Questions and answers

This manual is also suitable for:

Open enterprise server 2 sp2

Table of Contents