Cifs; Changing The Server Ip Address; Consoleone Can Cause Jclient Errors; Cups On Oes 2 - Novell OPEN ENTERPRISE SERVER 2 SP2 - PLANING AND IMPLEMENTATION GUIDE 11-10-2009 Implementation Manual

Planning and implementation guide
Table of Contents

Advertisement

NOTE: The list of users and groups in
SP2," on page 257
Create Only eDirectory Users and Groups
For OES 2 services, the LUM technology eliminates the need for local users and groups. We
recommend, therefore, that you avoid the problems discussed in this section by not creating local
users and groups.

6.3 CIFS

Section 6.3.1, "Changing the Server IP Address," on page 64

6.3.1 Changing the Server IP Address

Reconfiguring CIFS in YaST might not take effect if the server IP address was changed on the server
but not in the OES LDAP server configuration.
To work around this:
1 Reconfigure the LDAP server IP address with the IP address changes.
2 Then change the CIFS IP address configuration.

6.4 ConsoleOne Can Cause JClient Errors

ConsoleOne support is now limited to management of GroupWise and ZENworks for Desktops 7.
If you need to use ConsoleOne
you have installed version 1.3.6h or later.
Earlier versions of ConsoleOne cause JClient errors in iManager.

6.5 CUPS on OES 2

iPrint is the print solution for OES 2 and offers more robust and scalable print services than a CUPS
installation can. iPrint actually uses CUPS to render print jobs prior to sending them to the printer,
but for scalability and performance, printing from the server itself is disabled during iPrint
installation.
If you plan to use iPrint, deselect Print Server in the Primary Functions category during the install
and don't configure CUPS on the OES 2 server.

6.6 eDirectory

Section 6.6.1, "Avoid Uninstalling eDirectory," on page 65
Section 6.6.2, "Avoid Renaming Trees and Containers," on page 65
Section 6.6.3, "Default Static Cache Limit Might Be Inadequate," on page 65
Section 6.6.4, "eDirectory Fails to Start Automatically After a Command Prompt Install," on
page 65
64
OES 2 SP2: Planning and Implementation Guide
Appendix I, "System User and Group Management in OES 2
is not exhaustive. For example, the
®
to manage either of these supported products on OES 2, make sure
group is not listed.
users

Advertisement

Table of Contents
loading

This manual is also suitable for:

Open enterprise server 2 sp2

Table of Contents