Novell LINUX ENTERPRISE DESKTOP 11 - DEPLOYMENT GUIDE 17-03-2009 Deployment Manual page 151

4 Change to the directory of your installation repository and copy the isolinux
.cfg file to /srv/tftpboot/pxelinux.cfg/default by entering the
following:
cp -a boot/<architecture>/loader/isolinux.cfg
/srv/tftpboot/pxelinux.cfg/default
5 Edit the /srv/tftpboot/pxelinux.cfg/default file and remove the
lines beginning with gfxboot, readinfo, and framebuffer.
6 Insert the following entries in the append lines of the default failsafe and
apic labels:
insmod=kernel module
By means of this entry, enter the network kernel module needed to support
network installation on the PXE client. Replace kernel module with the
appropriate module name for your network device.
netdevice=interface
This entry defines the client's network interface that must be used for the
network installation. It is only necessary if the client is equipped with several
network cards and must be adapted accordingly. In case of a single network
card, this entry can be omitted.
install=nfs://ip_instserver/path_instsource/CD1
This entry defines the NFS server and the installation source for the client
installation. Replace ip_instserver with the actual IP address of your
installation server. path_instsource should be replaced with the actual
path to the installation sources. HTTP, FTP, or SMB sources are addressed
in a similar manner, except for the protocol prefix, which should read http,
ftp, or smb.
IMPORTANT
If you need to pass other boot options to the installation routines,
such as SSH or VNC boot parameters, append them to the install
entry. An overview of parameters and some examples are given in
Section 11.4, "Booting the Target System for Installation" (page 146).
Remote Installation 141