Novell LINUX ENTERPRISE DESKTOP 11 - DEPLOYMENT GUIDE 17-03-2009 Deployment Manual page 147

1 Log in as root to the machine hosting the DHCP server.
2 Start YaST > Network Services > DHCP Server.
3 Complete the setup wizard for basic DHCP server setup.
4 Select Expert Settings and select Yes when warned about leaving the start-up di-
alog.
5 In the Configured Declarations dialog, select the subnet in which the new system
should be located and click Edit.
6 In the Subnet Configuration dialog select Add to add a new option to the subnet's
configuration.
7 Select filename and enter pxelinux.0 as the value.
8 Add another option (next-server) and set its value to the address of the TFTP
server.
9 Select OK and Finish to complete the DHCP server configuration.
To configure DHCP to provide a static IP address to a specific host, enter the Expert
Settings of the DHCP server configuration module
declaration of the host type. Add the options hardware and fixed-address to
this host declaration and provide the appropriate values.
Setting Up a DHCP Server Manually
All the DHCP server needs to do, apart from providing automatic address allocation to
your network clients, is to announce the IP address of the TFTP server and the file that
should be pulled in by the installation routines on the target machine.
1 Log in as root to the machine hosting the DHCP server.
2 Append the following lines to a subnet configuration of your DHCP server's
configuration file located under /etc/dhcpd.conf:
subnet 192.168.1.0 netmask 255.255.255.0 {
range dynamic-bootp 192.168.1.200 192.168.1.228;
# PXE related stuff
(Step 4 (page 137)) and add a new
Remote Installation 137