Scheduling A Report - Novell IDENTITY AUDIT 1.0 - GUIDE Manual

5 Choose the language in which the report labels and descriptions should be displayed (English,
French, German, Italian, Japanese, Traditional Chinese, Simplified Chinese, Spanish, or
Portuguese).
The data in the report will be displayed in whatever language it was originally produced by the
event source.
6 If the report includes time period parameters, choose the date range. All time periods are based
on the local time for the browser.
Current Day: Shows events from midnight of the current day until 11:59 of the current
day. If the current time is 8AM, the report will show 8 hours of data.
Previous Day: Shows events from midnight yesterday until 11:59PM yesterday.
Week To Date: Shows events from midnight Sunday of the current week until the end of
the current day.
Previous Week: Shows last seven days of events.
Month to Date: Shows events from midnight the first day of the current month until the
end of the current day.
Previous Month: Shows a month of events, from midnight of the first day of the previous
month until 11:59 PM of the last day of the previous month
Custom Date Range: For this setting only, you also need to set a start date and end date
below.
7 If you selected Custom Date Range, set the start date (From Date) and the end date (To Date)
for the report.
If any of the other settings is selected for the report type, these time settings are ignored.
8 Set the Minimum Severity events to be included in the report.
9 Set the Maximum Severity events to be included in the report.
10 If the report should be mailed to a user or users, enter their e-mail addresses, separated by
commas.
To enable mailing reports, the administrator must configure the mail relay under Rules >
Configuration.
11 Click Run.
A report results entry is created and mailed to the designated recipients.

4.1.2 Scheduling a Report

When you run a report, you can run the report immediately or schedule it to be run later, either once
or on a recurring basis. For scheduled reports, you must choose a frequency and enter a time at
which the report should run.
Now: This is the default. It runs the report immediately.
Once: Runs the report once at the specified date and time.
Daily: Runs the report once a day at the specified time.
Weekly: Runs the report once a week on the same day at the specified time.
Monthly: Runs the report on the same day of the month every month, starting at the specified
date and time. For example, if the start date and time is October 28 at 2PM, the report will run
on the 28th day of the month at 2PM every month.
Reporting 29