The Activemq Module Fails To Start - Novell ACCESS MANAGER 3.1 SP2 - ACCESS GATEWAY GUIDE 2010 Manual

net start "Apache Tomcat"
5 (Linux) Restart Apache by using the following command:
/etc/init.d/novell-apache2 restart
Apache uses the terminal window to write the errors it discovers as it tries to process the
config.xml
6 (Windows) Run Apache in debug mode:
6a Use the following command to stop Apache:
net stop apache2.2
6b Change to the
6c Enter the following command:
httpd -e Debug
Apache writes to the terminal window the errors it discovers as it tries to processes the
config.xml
7 At the Administration Console, fix the configuration problems, then update the Access
Gateway.

8.6.4 The ActiveMQ Module Fails to Start

The Active MQ module is used for real-time communication between the Administration Console
and the Access Gateway Service. Real-time communication is needed for commands such as
purging cache, gathering statistics, and updating health.
flow.
Figure 8-3
Administration
Console
When the ActiveMQ module fails to start, you cannot apply any configuration changes, and the
Access Gateway does not set a listener for the configured port.
In order for the module to start, it must be able to resolve the listening IP address to a DNS name. To
install an Access Gateway Service, the machine must have a DNS name and the IP address must
resolve to this name.
256 Novell Access Manager 3.1 SP2 Access Gateway Guide
file.
\Program Files\novell\apache\bin
file.
Real-Time Communication
Real–Time Request
Figure 8-3
Access Gateway Service
AGM
JCC ActiveMQ
Apache
directory.
illustrates this communication