Table of Contents
Advertisement
Power > Advanced Tab.
•
Check "Turn off device if not used for"
Please select "On battery power" or "On
external power".
•
Select your desired time period.
•
Tap "OK" to complete this setting.
Power Mode
To turn off the device, press and hold Power
On/Off Key on the top of the device for about 5
seconds while the power is on.
1.9 My Information Setup
You can input your personal information to the
device in Owner Information.
1. Tap Start > Settings > Personal Tab >
Owner Information > Identification Tab.
2. Tap on "Name" field and input your name.
3. Tap on a desired input field and input your
information.
4. Tap on the Notes tap to input other
information you would like to display on
your device.
5. If you want your information to be displayed
on the starting screen, tap on the Options
tab, and check both "Identification
Information" and "Notes".
6. Select "OK" to finish setup and save it.
1.10 Password Setup
You can set your own password to prevent
unauthorized use of your device.
1. Tap Start > Settings > Personal Tab > Lock
> Password Tab.
2. On Password tab screen, check "Prompt if
device unused for".
3. Select an appropriate time.
4. Select a password type in "Password Type"
field.
5. Input your password in the "Password" field
and reconfirm the password in "Confirm".
6. Tap "OK", a pop-up window will appear to
confirm "Do you want to save password
settings changes?"
7. Tap "Yes" to finish settings and save the
changes; "No" to cancel.
8. You may also input password hint message
under the Hint tab screen.
9. Tap "OK" to save your inputs.
Note: If you forget your password, you
need to perform system default, which will
lose all your data and settings.
1.11 Device Lock
On "Today" screen, tap "Device unlocked" to
lock your device. When the device is locked,
the device will not respond to touches on
screen nor will it react to any input on the
keypad. You can enable device lock after
entering Sleep mode by pressing the power
key. To enable this setting, please follow the
steps below:
1. Tap Start > Settings > System Tab > Power
> Extended Tab
2. Check "Lock device when device enter
stand-by".
1.12 System Reboot and Reset
Reboot System:
When you reboot the device, all running
programs will stop and you will lose all
unsaved information. Please make sure that all
information has been saved before performing
system reboot.
1. Reboot button is located on the bottom right
side of your device.
2. Use the stylus to softly poke the reboot
button on the lower right side of the device
to reboot your system.
System Reset:
When executing system reset, you are
performing a clean boot on the device. It will
remove the programs you have installed on
this device, and reset all settings and
information back to factory defaults.
1. Turn off the device.
2. Press the Flag key and OK key at the same
1-5
MW998
Advertisement
Table of Contents
