Installing The Speakers On The Tallboy Stand - Samsung HT-C6730W User Manual

Connections

Installing the Speakers on the Tallboy Stand

1. Turn the Stand Base upside-down and connect it to the Stand.
2. Insert small screws (4x20, For connecting Stand & Stand Base) clockwise
into the four holes marked using a screwdriver as shown in the illustration.
!
CAUTION

When you use a torque screwdriver, be careful not to put
excessive force. Otherwise, it runs idle or can be damaged.
(torque screwdriver- below 15 kg.f.cm)
3. Connect the upper Speaker to the assembled Stand.
4. Insert another large screw (5x15, For connecting Speaker &
Stand) clockwise into the hole on the rear of the speaker using a
screwdriver.
5. This is the appearance after the speaker is installed.
Follow this steps to install other speaker.
20
English
1
Stand
Base
Stand
2
3
Speaker
Stand
4
5