Power
Power may be supplied by either a 9V battery (battery compartment under the
pedal) or an AC adapter (sold separately). Insert a plug into either input jack,
and the pedal powers up. To conserve the battery, remove the plug(s) from the
input jack(s) when not in use.
For AC power, use the Fishman 910-R (for 110V) or other suitable 9V adapter. The
adapter must be fi ltered, regulated and rated for at least 200mA. It must also
accept AC power appropriate for your country. Power-plug requirements: 5.5mm
O.D., 2mm I.D., tip = negative.
Delay Spillover
Normally, when the footswitch is pressed to bypass the effect, the analog audio
path is selected and the delay is cut off abruptly. Instead, you can choose to al-
low the delay to repeat normally when in bypass by selecting delay spillover
mode. To do this, power up the the pedal while holding the footswitch until
the footswitch light fl ashes quickly. To revert back to analog bypass, repeat this
power-up sequence.
9