Table of Contents
Advertisement
by Software (BIOS)
Host/PCI clock at Next boot is
When Clock Control setting By Software this item allows you to set CPU Host Clock step
by step from 100MHz to 200MHz, use Page Down/Page Up key can change the frequency
to approach over clocking.
DRAM Clock at Next Boot is
This item allows you to set the DRAM clock synchronous as CPU Host Clock or
Asynchronous as Host clock 100MHz, 133MHz, 166MHz to approach your DDR SDRAM
specification.
CPU Vcore Select
This item allows you to set the CPU Voltage from 1.6V to 1.85V.
3-12 Load Standard/Optimized Defaults
Load Standard Defaults
When you press <Enter> on this item, you get confirmation dialog box with a message
similar to:
Load Standard Defaults (Y/N)? N
Pressing <Y> loads the BIOS default values for the most stable, minimal-performance
system operations.
Load Optimized Defaults
When you press <Enter> on this item, you get a confirmation dialog box with a message
similar to:
Load Optimized Defaults (Y/N)? N
Pressing <Y> loads the default values that are factory settings for optimal performance
system operations.
3-13 Set Supervisor/User Password
You can set either supervisor or user password, or both of them. The differences are:
Supervisor password:
User password:
ENTER PASSWORD:
Type the password, up to eight characters in length, and press <Enter>. The password
Can enter and change the options of the setup menus.
Can only enter but do not have the right to change the options of
the setup menus. When you select this function, the following
message will appear at the center of the screen to assist you in
creating a password.
38
Advertisement
Table of Contents
