Headers - JETWAY S446R2A User Manual

•
Two hard disks can be connected to each connector. The first HDD is referred to as
the "Master" and the second HDD is referred to as the "Slave".
•
For performance issues, we strongly suggest you don't install a CD-ROM or DVD-
ROM drive on the same IDE channel as a hard disk. Otherwise, the system performance
on this channel may drop.
(12) IDE RAID Connectors : IDE3/IDE4 (Only for S446R)
When JP4 setting 1-2 closed IDE3/IDE4 are setting in ATA 100 Mode for Normal
extra IDE Interface. When JP4 setting 2-3 closed IDE3/IDE4 can setting RAID Mode
for stripping capable to increase transfer rate, or RAID 1 Mode for mirroring capable
for data protection. For more detail description please read PROMISE.DOC in CD-
PACK X:\MANUAL\PROMISE.DOC file.

2-6-2 Headers

(1) Line-Out/MIC Header for Front Panel (9-pin): FAUDIO
This header connect to Front Panel Line-out, MIC connector with cable.
Without install the cable, this header default setting is 5-6 short, 9-10 short. When
you install the cable you have take off these jumpers.
(2) USB Port Headers (9-pin) : USB2
These headers are used for connecting the additional USB port plug. By attaching an
option USB cable, your can be provided with two additional USB plugs affixed to the
back panel.
Pin 1
Pin 1
IDE RAID Connectors
FAUDIO
10 9
AUD _ RET _ L AUD _ FPOUT _ L
AUD _ RET _ R AUD _ FPOUT _ R
AUD _ VCC
AUD _ MIC _ BIAS
AUD _ MIC
AUD _ GND
2
Pin 1
Line-Out, MIC Headers
17
IDE4
IDE3
HP _ ON