Table of Contents
Advertisement
(2) Keyboard Power On function Enabled/Disabled: JP1
When setting Enabled you can using keyboard by key in password to power on system.
(3) ATA100/RAID Mode Selector: JP4 (Only for S446R)
When JP4 1-2 closed the IDE3 & IDE4 are setting in ATA100 Mode supports Ultra
DMA 100MB/sec transfer rate.
When JP4 2-3 closed the IDE3 & IDE4 are setting in RAID Mode supports RAID 0
(striping) to increase hard drive performance or RAID 1 (mirroring) to protect hard
drive data, for more detail information please refer CD-PACK in
X:\MANUAL\PROMISE.DOC
Note:
If you only install hard drive in IDE3 and IDE4 and the JP4 setting 2-3 closed
then this driver must install IDE RAID 0 or IDE RAID 1 Mode by Fast Build
Utility, please press <Ctrl-F> to enter setup Main Menu and choose "Auto
Setup" to setup your hard drive.
1
3
JP1
1-2 closed
K/B Power ON Disable
(Default)
Keyboard Power On Setting
1
3
JP4
1-2 closed ATA100 Mode
ATA 100/RAID Mode Selector
8
1
3
JP1
2-3 closed
K/B Power ON Enabled
1
3
JP4
2-3 closed RAID Mode
(Default)
Advertisement
Table of Contents
