JETWAY J9BXAS-7A User Manual page 30

-12V Low Limit/High Limit
These values are used to specify the threshold values of detecting the abnormal condition of ,
3.3V, +5V, +12V, -12V.
2. FAN Speed
CPUFAN/ SYSFAN
If the fan RPM is lower than this value and "CPUFAN/SYSFAN" is enabled in Monitoring Config.
the PC Speaker will alarm and the monitor software will pop up a window to inform user.
3. Temperature
System/ CPU Low Limit/ High Limit
There values is used to specify the Temp-Over register/ Tem-under register of PC HEALTH
MONITOR CHIP, If the temperature of the external thermistor is higher than this value and
"System/CPU" is enabled in Monitoring Config. the monitor software will pop up a window to
inform user.
Monitoring Config.
Enabled or Disabled: User can decide which item should be monitored or not by choosing the
Faults Count (1 or 3): User can decide the system to pop up the warning message when there is
Beep:
4-2 Sound Driver & Audio Rack Installation:
Special Features for CMI8738 audio chip
PCI Plug and Play (PnP) bus interface, 32 bit PCI bus master.
Full duplex playback and recording, built-in 16 bits CODEC.
HRTF 3D positional audio, supports both Direct Sound 3D ® & A3D® interfaces, supports earphones, two
item in the configuration page.
1 fault detected or there are 3 consecutive faults detected.
In addition to pop up warning message user can choose to activate Beep
tone if there is error detected. Beep tone will until the error is treated.
28