JETWAY J9BXAS-7A User Manual page 16

7. Primary IDE Connector (40-pin block): IDE1
This connector supports the provided IDE hard disk ribbon cable. After connecting the single
plug end to motherboard, connect the two plugs at other end to your hard disk(s). If you install
two hard disks, you must configure the second drive to Slave mode by setting its jumpers
accordingly. Please refer to the documentation of your hard disk for the jumper settings.
8. Secondary IDE Connector (40-pin block): IDE2
This connector connects to the next set of Master and Slave hard disks. Follow the same
procedure described for the primary IDE connector. You may also configure two hard disks to
be both Masters using one ribbon cable on the primary IDE connector and another ribbon
cable on the secondary IDE connector.
9. IDE activity LED: HDLED
This connector connects to the hard disk activity indicator light on the case.
10. Turbo LED switch: TBLED
The motherboard's turbo function is always on. The turbo LED will remain constantly lit while
the system power is on. You may wish to connect the Power LED from the system case to
this lead. See the figure below.
Pin 1
Floppy drive Connector
Pin 1
Secondary IDE Connector
Pin 1
Secondary IDE Connector
HDLED
IDE (Hard Drive) LED
14