AkitikA PR-101 Assembly Manual
Stereo preamplifier
Hide thumbs
Also See for PR-101:
- Assembly manual (68 pages) ,
- Assembly manual (24 pages) ,
- Assembly manual (53 pages)
Related Manuals for AkitikA PR-101
Summary of Contents for AkitikA PR-101
- Page 1 PR-101/PR-102 STEREO PREAMPLIFIER Quarter Inch Jack for Headphone Amp ASSEMBLY MANUAL © 2018 AkitikA LLC All rights reserved Revision 1p01 June 27, 2025 Page 1 of 6...
-
Page 2: Table Of Contents
Table of Contents Table of Contents ........................ 2 Table of Figures ........................2 Section 1: About This Manual .................... 3 Who Should Attempt this Project? ................. 3 Tools you’ll need ......................3 Helpful Tools ........................3 Project Overview ......................3 Important Safety Notes .................... -
Page 3: Section 1: About This Manual
Section 1: About This Manual This manual gives the information needed to convert the PR-101 preamp and Headphone Amp for Akitika LLC’s PR-101 Stereo Preamplifier from its supplied 1/8” jack to the ¼” jack shown on the cover. Who Should Attempt this Project? You can build this kit if you can: 1. -
Page 4: Important Safety Notes
60/40 Rosin Core solder. Akitika LLC’s liability shall in no event exceed the cost paid to Akitika LLC for the kit. Page 4 of 6... -
Page 5: Section 2: Preliminary Steps
Section 2: Preliminary Steps 1. Disconnect the preamp from power and from your system. 2. Remove the 11 screws that hold the cover in place. Remove the cover. 3. Remove the balance, bass, treble, and volume knobs. They sit on splined shafts, and just pull off. -
Page 6: Section 3: Final Steps
Figure 1-Installing and wiring the quarter inch jack Section 3: Final steps Re-install the tone volume board. Re-connect the 10-pin control cable if you removed it earlier. 1. Insert the controls through the front panel. Fasten the tone-volume board back in place using the two 4-40 keps nuts at the back of the PCB.
Need help?
Do you have a question about the PR-101 and is the answer not in the manual?
Questions and answers