Advertisement
Quick Links
Advertisement
Related Manuals for TMC Reef Bio-Gro 2.0 S
Summary of Contents for TMC Reef Bio-Gro 2.0 S
- Page 1 Reef Bio-Gro 2.0 S and M INSTRUCTIONS...
- Page 3 SPECIFICATION Code 1442 1443 Model Reef Bio-Gro 2.0 S Reef Bio-Gro 2.0 M Volume 4.4l 8.7l (1.2 US gal) (2.3 US gal) Inlet/Outlet 16mm 18mm (0.6 US gal) (0.7 US gal) LED Power 195 x 165 x 465 mm 230 x 200 x 565 mm Dimensions 7.6”...
- Page 4 INSTRUCTIONS FOR INSTALLATION AND USE Important Safety Information - Please Read Carefully • Always isolate from the mains electricity before installing or carrying out any maintenance to the Reef Bio-Gro 2.0 unit. • This product should only be used with an approved power supply unit (PSU). Failure to do so may result in serious harm to you and damage to the unit.
- Page 5 PARTS LIST 1. Water inlet 2. Lid 3. Lid O ring – not shown 4. Water outlet 5. LED lighting board protection tube 6. Double-sided LED lighting board 7. Macroalgae cultivation plates 8. Growing chamber 9. LED lighting board cable gland 10.
- Page 6 INTRODUCTION The Reef Bio-Gro 2.0 is an advanced, compact reactor specifically designed to grow macro-algae. It incorporates a high performance, double-sided LED lighting board, using AquaRay technology, with LED diodes selected specifically to promote optimum algae growth inside the reactor. This macroalgae can be used to reduce unwanted nutrients such as nitrate and phosphate in your reef aquarium and also help improve water quality.
- Page 7 INSTALLATION 1. Position the reactor so it can be easily connected to the water outlet of your pump and so the exiting water can readily feed back into your aquarium or sump. Ensure there is adequate space for the reactor to be accessed for harvesting algae, cleaning and maintenance.
- Page 8 • If the DC cable becomes damaged the LED lighting board should be disconnected immediately from the mains electricity supply. • The DC cable cannot be replaced so, if damaged, the LED lighting board should be returned to TMC or disposed of responsibly. Check with your local authority for disposal information.
- Page 9 TROUBLE SHOOTING Problem: Water flow through the reactor is not sufficient Possible Cause: Water flow rate to the reactor is incorrect. Solution: Adjust water flow to the reactor accordingly. Possible Cause: Pump is not plugged in or is not operating correctly. Solution: Refer to the instructions supplied with your pump.
- Page 12 tropicalmarinecentre.com info@tropicalmarinecentre.co.uk Europe Solesbridge Lane Rua Cidade de Paris 6 Chorleywood Parque Industrial do Arneiro Hertfordshire WD3 5SX 2660-456 São Julião do Tojal England Portugal Call +351 219 739 140 Call +44 (0) 1923 284151...
Need help?
Do you have a question about the Reef Bio-Gro 2.0 S and is the answer not in the manual?
Questions and answers