Nobles Speed Scrub 2401 Use And Care Manual

USE and CARE Guide
DAILY: BE
WARNING: Failure to follow these warnings may result in personal injury, electrocution, electrical shock, fire
or explosion: Do not use flammable liquids or operate machine in or near flammable liquids, vapors or
combustible dusts. Do not pick up flammable materials or reactive metals. Keep sparks and open flame away.
Keep battery hood open when charging. Disconnect battery cables before servicing machine.
DAILY: BEFORE EACH USE
1. Sweep and dust
1. Sweep and dust
mop floor before
scrubbing.
mop floor before
6. Make sure recovery
scrubbing.
tank is empty and the
float screen is installed
and clean.
DAILY: AFTER EACH USE
1. Drain and rinse out
recovery tank.
6. Clean machine with
an all purpose cleaner
and damp cloth.
MONTHLY:
1. Remove and clean
the solution tank filter
(clear bowl). Empty
tank before removing.
2401/2601 Speed Scrub
2. Check battery
meter charge level.
7. FaSTt Model –
Check the FaSTt PAK
agent level. Replace
PAK as needed.
2. Remove and rinse
off float screen filter.
7. FaSTt Model –
Connect FaSTt PAK
supply hose to storing
plug when not in use.
Refer to Operator's Manual for further details.
2. Lubricate caster
fittings with a water
resistant grease.
3. Check all switches
to make sure they
operate properly.
8. FaSTt Model –
Check that the supply
hose is properly con-
nected to FaSTt PAK.
3. Drain and rinse out
solution tank.
8. Recharge batteries
ONLY if machine is used
30 minutes or more.
3. Clean battery tops
and terminals. Use a
strong mixture of
baking soda and water.
Disc Model
4. Check condition of
scrubbing pads.
Replace if worn.
9. For Conventional
Scrubbing Only – Fill
solution tank with water
(1405 max.) and add
4. Remove pads/
brushes and clean.
9. Check battery fluid
level before charging.
4. Flush the solution
system with an acetic
acid solution.
5. Clean squeegee
and check condition of
wiping edge. Rotate
blade if worn.
approved cleaning
agents.
FaSTt Model – USE
CLEAR COOL WATER
ONLY. DO NOT add
cleaning agents into the
solution tank or damage
may result.
5. Wipe clean the
squeegee blades.
The fluid level (A)
should cover battery
plates (B) by 1/4". Add
distilled water if
needed.
B
A
5. FaSTt Model –
Remove and clean the
air pump filter every
250 hours.