Configuring The Pta Plug-In - Netscape DIRECTORY SERVER 6.02 - ADMINISTRATOR Administrator's Manual

PTA Plug-In Parameters (Continued)
Table 16-1
Variable
maxconns
maxops
timeout
ldver
connlifetime

Configuring the PTA Plug-In

The only method for configuring the PTA plug-in is to modify the entry
cn=Pass Through Authentication,cn=plugins,cn=config
To modify the
Use the
1.
Authentication,cn=plugins,cn=config
Definition
Optional. The maximum number of connections the PTA directory can
simultaneously open to the authenticating directory. The default is 3.
See "Configuring the Optional Parameters," on page 463 for more information.
Optional. The maximum number of simultaneous operations (usually bind
requests) the PTA directory can send to the authenticating directory within a
single connection. The default is 5.
See "Configuring the Optional Parameters," on page 463 for more information.
Optional. The time limit, in seconds, that the PTA directory waits for a response
from the authenticating directory server. If this timeout is exceeded, the server
returns an error to the client.
The default is 300 seconds (five minutes). Specify zero (0) to indicate no time
limit should be enforced.
See "Configuring the Optional Parameters," on page 463 for more information.
Optional. The version of the LDAP protocol used to connect to the
authenticating directory. Directory Server supports LDAP version 2 and 3. The
default is version 3.
See "Configuring the Optional Parameters," on page 463 for more information.
Optional. The time limit, in seconds, within which a connection may be used. If a
bind request is initiated by a client after this time has expired, the server closes
the connection and opens a new connection to the authenticating directory. The
server will not close the connection unless a bind request is initiated and the
directory determines the connection lifetime has been exceeded.
If you do not specify this option, or if only one host is listed, no connection
lifetime will be enforced. If two or more hosts are listed, the default is 300
seconds (five minutes).
See "Configuring the Optional Parameters," on page 463 for more information.
file, you must proceed as follows:
dse.ldif
command to modify
ldapmodify cn=Pass Through
Chapter 16 Using the Pass-Through Authentication Plug-In
Configuring the PTA Plug-In
in the file.
dse.ldif
459