Related Manuals for SOMFY Eolis 3D WireFree io
Summary of Contents for SOMFY Eolis 3D WireFree io
- Page 1 Eolis 3D WireFree™ io Installatiegids Installer guide Guía del instalador...
- Page 2 (niet bijgeleverd), 2 schroeven Druk op de toet zonken kop met een diameter van lokale Somfy io-m niet bijgeleverd), 2 klinknagels met de toepassing op meter van 4 mm (niet bijgeleverd) (≈ 2 sec.).
- Page 3 La sacudida se detecta más fácilmente en los posición seleccionada no impide cerrar el toldo movimiento inalámbrico tridimensional, equipado PROG. 2 s Somfy. Esto invalidaría la garantía y eximiría de Eolis 3D WireFree™ io con tecnología de radio io-homecontrol ®...
- Page 4 Demonstration mode. Set the potentiometer (h) to 0 using a flat screwdriver. WireFree™ io op de toets PROG. van de lokale Somfy io-muurzender vervan When replacing the batteries, the specific adjustments WireFree™ io Press the PROG.
-
Page 5: Installer Manual
2. Safety 2.1. Safety and responsibility Before installing and using this product, please read this guide carefully. This Somfy product must be installed by a motorization and home automation professional, for whom this guide is intended. Moreover, the installer must comply with... - Page 6 Do not submerge it. Do not use abrasive products or solvents to clean the product. Do not clean it using a water spray or high pressure cleaning method. Ensure that the sensor is kept clean and regularly check it is operating correctly.
-
Page 7: Installing The Batteries
2 countersunk-head screws 4 mm in diameter (not supplied), 2 pop rivets 4 mm in diameter (not supplied) or 2 Somfy fixing accessories (not supplied). Position the support (g) on the inside of the load bar and check that the... - Page 8 The motor must already be set and ® paired to a local io-homecontrol control point Press the PROG. button on the Somfy io local control point , until the end product performs an up and down movement (≈ 2 secs.).
- Page 9 io is set to threshold 2, which corresponds to an average level of sensitivity to shaking to ensure the safety of most end products. “ ” Adjustment to a Pre-defined threshold Figure H Set the potentiometer (h) to the desired threshold using a flat screwdriver : Threshold 1 : low intensity shaking will cause the awning to rise.
- Page 10 WireFree™ io Figure K After fitting the batteries in the new Eolis 3D WireFree™ io, press the PROG. button on the Somfy io local control point , until the end product performs an up and down movement (≈ 2 secs.).
- Page 11 8.3. Returning the Eolis 3D WireFree™ io to its original configuration Press the PROG. button (i) of the Eolis 3D WireFree™ io for 7 seconds : The green indicator light (k) will come on for 2 seconds and remain lit for 5 seconds. The Eolis 3D WireFree™...
-
Page 12: Technical Data
(≈ 2 secs.). 4 mm in diameter (not supplied) or 2 Radio frequency : Briefly press the PROG. bu Somfy fixing accessories (not supplied). the sensor : the end product ed to (g) on the inside Position the support...
Need help?
Do you have a question about the Eolis 3D WireFree io and is the answer not in the manual?
Questions and answers