Summary of Contents for DeLonghi MAGNIFICA START ECAM22 3 Series
Page 1
ECAM22X.2Y - 22X.3 Y- 22X.4Y- 22X.5Y - FEB222Y - 223Y - 224Y - 225Y BEAN TO CUP ESPRESSO AND CAPPUCCINO MACHINE Instructions for Use...
Page 3
Decalci cante per macchine da ca è Descaler for co ee machines Détartrant pour machines à café Entkalker für Ka eemaschinen De’Longhi Appliances s.r.l. Via L. Seitz, 47 31100 Treviso - ITALY Tel. +39 0422 4131 5413218631/04.15 ✕ ✕ ✕ ✓...
Before using the appliance for the first time, be CONTENTS sure to read the safety warnings. 1. INTRODUCTION ........4 1.1 Letters in brackets ........4 1. INTRODUCTION 1.2 Troubleshooting and repairs ....4 Take a few minutes to read these Instructions for Use. This will 2.
A9. Water tank proof of the meticulous care and attention we invest in A10. Coffee grounds container our products. A11. Drip tray (varies according to model) • The first time the machine is used, the water circuit will be empty and the appliance could be very noisy.The noise A12.
3. Remove the strip from the water and shake lightly (fig. 5. Press the button(B3) (fig. 7): the internal water 9). After about a minute, 1, 2, 3, or 4 red squares appear, circuits start to fill and the appliance will release hot water depending on the hardness of the water.
Please note: Drink Default Programmable quantity If the appliance is not going to be used for some time, unplug quantity (ml) it from the mains socket: (ml) • first turn the appliance off by pressing the button; from ≃40 to ≃ 240 •...
Medium Strong 2. Select the desired coffee drink. Please note: • When the next coffee is made, the machine will show the last intensity setting selected. • In the event of power failure, the machine will revert to 3 12 the medium default setting.
For a fuller bodied creamier Turn one click towards “1” coffee This adjustment will not take ef- fect until at least 2 cups of coffee have been delivered. Please note: The adjustment dial must be turned only when the coffee mill is in operation during the initial step of coffee preparation.
To ensure the performance of the machine remains constant 0,5 L over time, we recommend using a De’Longhi water softener filter. For more information, visit the www.delonghi.com website. 7. See instructions in section “12. Settings menu” for instal- EAN: 8004399327252 lation of the filter;...
Please note: 8. The Led relative to the Steam/Hot water dial starts After two months (see date indicator) or when the appliance flashing rapidly: turn the steam/hot water dial (A19) to has not been used for 3 weeks,the filter should be replaced the I position (fig.
Page 12
1. Access the menu: Press and hold the button for a few seconds: the settings buttons light up. Proceed by pressing the button corresponding to the setting to be adjusted. 2. Adjust the machine settings: Water softener filter Confirm selection Press the intensity button FILTER IN PLACE repeatedly until the Leds...
Energy saving Confirm selection Press the intensity button repeatedly until the Leds relative to the desired setting light up LEVEL 1 Water hardness Confirm selection Press the intensity button repeatedly until the Led corresponding to the LEVEL 2 required level lights up LEVEL 3 LEVEL 4 15 MINUTES...
12.1 Reset default values Make sure the machine is in stand-by (off, but connected to the mains power supply). Press the buttons corresponding to drinks 1, 2 and hold for 5 seconds. All the settings and drink quantities are reset to the default values.
Page 15
Component Frequency Procedure Grounds container (A10) • Remove the drip tray (A11), empty and clean. When the indicator (B12) lights up, • Empty the grounds container and clean thoroughly the grounds container must be emptied: to remove all residues that may have collected on the machine cannot now make coffee.
14. CLEANING THE BREWING UNIT Important! The brewing unit (A6) cannot be removed while the machine is on. 1. Press the button (B1)to turn the machine off; 2. Remove the water tank (A9); 3. Open the brewing unit door, positioned on the right hand side (fig.
Page 17
mild intensity Led lights up to indicate that step 1 of the water, then fill with fresh water up to the MAX level (fig. descale cycle is in progress; 30) and reposition in the machine; reposition the contain- 2. Empty the drip tray (A11) and the grounds container er under the spouts;...
and the drip tray, in which part of the rinse water will Indicator/Led Meaning have been collected; finally, refill the water tank. General alarm: the inside of 16. Reposition all components in the machine. the machine is very dirty. The machine is ready for use. Clean the machine thor- Please note: oughly.
Page 19
Indicator/Led Meaning Indicator/Led Meaning Too much coffee has been grounds container needs emptying (A10). used. Select a milder taste or reduce the quantity of pre-ground coffee. The grounds container (A10) is missing, or not inserted A selection has been made correctly: insert the drip tray using pre-ground coffee complete with grounds con-...
17. TROUBLESHOOTING Below is a list of some of the possible malfunctions. If the problem cannot be resolved as described, contact customer services. PROBLEM POSSIBLE CAUSE REMEDY The appliance does not come on. It is not plugged into the mains socket. Plug into the mains socket.
PROBLEM POSSIBLE CAUSE REMEDY The brewing unit cannot be extracted. The machine has not been turned off. Turn the machine off by pressing the button. On completion of the descale cycle, the During the two rinse cycles, the water Restart the descaling procedure from “Step machine calls for a further rinse tank has not been filled to the MAX level Second rinse”.
Need help?
Do you have a question about the MAGNIFICA START ECAM22 3 Series and is the answer not in the manual?
Questions and answers